What is AHCI mode in BIOS Reason 2: False impulse So if you can’t find the names of the lines, try to find the closest one or use another instruction in the link below. Please note that the location of specific and even general settings in your BIOS may be different from what is described in the manual. Translating the connection type should be enough for the firmware to see the drive and start communicating with it, if that was the problem. “F10” to initialize the output and save the changes made, and press “OK”. Find the line “Controller Mode”and if there is a different mode than specified in the Kingston SSD Manager system requirements, for example, “IDE”The source of the problem has been identified.Go to the “Advanced” tab and then move the highlighted area to “Onboard device settings” and press “Enter”.To change this, go into the BIOS and follow the steps below:Īlso read: How to enter the BIOS of your computer It means that communication using outdated connection protocols is not supported, and if you used older drives before, you probably have the corresponding settings. We must look for the causes of the failure in the BIOS or in Windows, specifically in the connection settings between the unit and the computer, as well as in the device itself, which can hide a failure.Īlthough there is no need to actively detect Kingston SSD Manager devices directly, the developers put this system requirement: AHCI mode enabled in the BIOS. What remains to be understood is why specialized proprietary software cannot detect the SSD. If the operating system itself can detect the SSD, it’s not so bad.

If Kingston SSD Manager doesn’t detect the newly connected drive or doesn’t see any devices when you launch it, then there is a hardware failure or worse.īut don’t despair. Therefore, in the normal operating mode of the system, you should not need to take any further action, apart from connecting the Kingston SSD.Ĭonnect an SSD to your computer or laptopĬonnecting an SSD to a PCI Express x4 SSD slot The manager program should automatically detect the presence of SSD in your computer. Today we are going to tell you why Kingston SSD Manager does not see the SSD and how to get out of this situation. Kingston SSD Manager does not see the SSDĪ special utility for interfacing with Kingston’s proprietary solid-state drives monitors serviceability, health, and various aspects of disk usage. Kingston SSD Manager can’t see your SSD.

Kingston ssd manager windows 7