wireshark display filter mac address wildcard

Multiple commands can reference the same access list. Many software commands accept an access list as part of their syntax.Īn access list can be configured and named, but it is not in effect until the access list is referenced by a command that accepts an access list. The access list has a name by which it is referenced.

Then I could add say 15 deny x.x.x.x, but now I cant and I dont even know what happened to the sequence numbers when I created them.Īn access list is a sequential list consisting of at least one permit statement and possibly one or more denystatements that apply to IP addresses and possibly upper-layer IP protocols. What went wrong? How is it possible to edit an acl without sequence numbers also? Even though I created sequence numbers in order of the 3 entries (10,20,30) the sequence numbers didnt put them in order and they dont even show up in the show run.

From what I need to put the 3rd entry (deny host 10.1.30.51) after the second entry and before the permit any. I had the first two lines in the access list and all was well, I then added the 3rd.

Wireshark display filter mac address wildcard